Saving Configuration Changes - Nortel 2300 Series Configuration Manual

Saving Configuration Changes

To save the running configuration to a configuration file, use the following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters, the command replaces the startup
configuration file that was loaded the last time the software was rebooted. (To display the filename of that
configuration file, see "Displaying Boot Information" on page
To save the running configuration to the file loaded the last time the software was rebooted, type the following
command:
23x0# save config
success: configuration saved.
To save the running configuration to a file named newconfig, type the following command:
23x0# save config newconfig
success: configuration saved to newconfig.
520.)
Nortel WLAN Security Switch 2300 Series Configuration Guide
Managing System Files 529