Displaying A List Of Distributed Aps - Nortel 2300 Series Configuration Manual

Displaying a List of Distributed APs

To display a list of the Distributed APs configured on WSS switches in the Mobility Domain, use the following
command:
show dap global [dap-num | serial-id serial-ID]
This command lists the System IP addresses of all the WSS switches on which each Distributed AP is configured, and
lists the bias for the AP on each switch. For each Distributed AP that is configured on the switch on which you use the
command, the connection number is also listed.
To display information for all Distributed APs configured on all WSS switches in the Mobility Domain, type the
following command:
23x0# show dap global
Total number of entries: 8
DAP Serial Id
--- ----------- --------------- ----
1 11223344
- 11223344
2 332211
- 332211
17 0322100185
- 0322100185
18 0321500120
- 0321500120
This command indicates that the Mobility Domain contains four Distributed APs, with serial IDs 11223344, 332211,
0322100185, and 0321500120. Each AP is configured on two WSS switches, with system IP addresses 10.3.8.111 and
10.4.3.2. The bias for the AP on each WSS switch is listed. Normally, a Distributed AP boots from the WSS switch with
the high bias for the AP. (For more information, see
"AP Boot Process" on page
The DAP field indicates the connection number of each AP on the WSS switch on which the command is typed. A
hyphen ( - ) in the DAP field indicates that the AP is configured on another WSS switch in the same Mobility Domain.
WSS IP Address
10.3.8.111
10.4.3.2
10.3.8.111
10.4.3.2
10.3.8.111
10.4.3.2
10.3.8.111
10.4.3.2
"Resiliency and Dual-Homing Options for APs" on page 227
231.)
Nortel WLAN Security Switch 2300 Series Configuration Guide
Configuring AP access points 283
Bias
HIGH
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH
and