Configuring Member Wsss On The Seed - Nortel 2300 Series Configuration Manual

Wlan security switch

Hide thumbs Also See for 2300 Series:

Table of Contents

178 Configuring and Managing Mobility Domain Roaming

Configuring Member WSSs on the Seed

To configure the list of members on the Mobility Domain seed for distribution to other member WSSs, use the following

command on the seed WSS:

set mobility-domain member ip-addr

For example, the following commands add two members with IP addresses 192.168.12.7 and 192.168.15.5 to a Mobility

Domain whose seed is the current WSS:

23x0# set mobility-domain member 192.168.12.7

success: change accepted.

23x0# set mobility-domain member 192.168.15.5

success: change accepted.

Each command adds a member identified by its IP address to the list of Mobility Domain members. If the WSS from

which you enter the command is not configured as a seed, the command is rejected.