Nortel 2300 Series Configuration Manual page 424

424 Configuring AAA for Network Users
for bonded authentication of all users at mycorp.com (*.mycorp.com). Both rules use pass-through as the protocol, and
use RADIUS server group radgrp1.
23x0# set authentication dot1x ssid mycorp host/*-laptop.mycorp.com pass-through radgrp1
success: change accepted.
23x0# set authentication dot1x ssid mycorp *.mycorp.com bonded pass-through radgrp1
success: change accepted.
The following command sets the Bonded Authentication period to 60 seconds, to allow time for WEP users to
reauthenticate:
23x0# set dot1x bonded-period 60
success: change accepted.
Displaying Bonded Authentication Configuration Information
To display Bonded Authentication configuration information, use the following command:
show dot1x config
In the following example, bob.mycorp.com uses Bonded Authentication, and the Bonded Authentication period is set to
60 seconds.
23x0# show dot1x config
'host/bob-laptop.mycorp.com' on ssid 'mycorp' doing PASSTHRU
'bob.mycorp.com' on ssid 'mycorp' doing PASSTHRU (bonded)
802.1X parameter
----------------
supplicant timeout
auth-server timeout
quiet period
transmit period
reauthentication period
maximum requests
key transmission
reauthentication
authentication control
WEP rekey period
WEP rekey
Bonded period
320657-A
802.1X user policy
----------------------
setting
-------
30
30
60
5
3600
2
enabled
enabled
enabled
1800
enabled
60