Syntax Notation - Nortel 2300 Series Configuration Manual

Wlan security switch

Hide thumbs Also See for 2300 Series:

Table of Contents

Syntax Notation

The WSS Software CLI uses standard syntax notation:

Bold monospace font identifies the command and keywords you must type. For example:

set enablepass

Italic monospace font indicates a placeholder for a value. For example, you replace vlan-id in the

following command with a virtual LAN (VLAN) ID:

clear interface vlan-id ip

Curly brackets ({ }) indicate a mandatory parameter, and square brackets ([ ]) indicate an optional

parameter. For example, you must enter dynamic or port and a port list in the following command, but a

VLAN ID is optional:

clear fdb {dynamic | port port-list} [vlan vlan-id]

A vertical bar (|) separates mutually exclusive options within a list of possibilities. For example, you enter

either enable or disable, not both, in the following command:

set port {enable | disable} port-list

Nortel WLAN Security Switch 2300 Series Configuration Guide

Using the Command-Line Interface 37