Nortel 2300 Series Configuration Manual page 238

238 Configuring AP access points
bias set on any of the WSS switches configured for the AP. Only in the event of a physical port failure would
the AP attempt to boot from its port 2.
Figure 14. Dual-Homed AP Booting
WSS1
System IP address
10.10.10.4
active APs = 49
AP port 4
model ap-2330
Port
PoE enabled
1
serial_id 0322199999
model ap-2330
1
AP sends a DHCP Discover message from the AP's port 1.
2
Because WSS1 is configured for direct attachment, WSS1 responds privately to the AP and
provides the AP with its software image and configuration from WSS1. Only in the event of a
physical port failure would the AP attempt to boot from its port 2, in which case both WSS1
and WSS2 would respond to the broadcast Find WSS message.
320657-A
2
4
DAP 1
serial_id 0322199999
model ap-2330
Layer 2
DHCP Server
WSS2
System IP address
10.10.40.4
active APs = 34
Router
Router
Layer 2
WSS3
System IP address
10.10.50.4
active APs = 62
DAP 1
serial_id 0322199999
model ap-2330