Displaying Ap Configuration Information - Nortel 2300 Series Configuration Manual

282 Configuring AP access points

Displaying AP Configuration Information

To display configuration information, use the following commands:
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
The command lists information separately for each AP access port.
To display configuration information for an AP access point on WSS port 2, type the following command:
23x0# show ap config 2
Port 2: AP model: 2330, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel:
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
To display configuration information for a Distributed AP access point configured on connection 1, type the
following command:
23x0# show dap config 1
Dap 1: serial-id:
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel:
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
(For information about the fields in the output, see the Nortel Mobility System Software Command Reference.)
320657-A
enable, bias: high, name: AP02
12345678, AP model: 2330, bias: high, name: DAP01
6
6