Displaying Port Information - Nortel 2300 Series Configuration Manual

Wlan security switch

Hide thumbs Also See for 2300 Series:

Table of Contents

84 Configuring and Managing Ports and VLANs

Displaying Port Information

You can use CLI commands to display the following port information:

Port configuration and status

Port statistics

You also can configure WSS Software to display and regularly update port statistics in a separate window.

Displaying Port Configuration and Status

To display port configuration and status information, use the following command:

show port status [port-list]

To display information for all ports, type the following command:

23x0# show port status

===============================================================================

In this example, three of the switch's ports, 1, 9, and 10, have an operational status of up, indicating the links on the ports

are available. Ports 1 and 10 are network ports. Port 9 is an AP access port.

(For more information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software Command

Displaying PoE State

To display the PoE state of a port, use the following command:

show port poe [port-list]

To display PoE information for ports 7 and 9, type the following command:

10/100BaseTx

no connector