Configuring An Attack List - Nortel 2300 Series Configuration Manual

Configuring an Attack List

The attack list specifies the MAC address of devices that WSS Software should issue countermeasures against whenever
the devices are detected on the network. The attack list can contain the MAC addresses of APs and clients.
By default, the attack list is empty. The attack list applies only to the WSS switch on which the list is configured. WSS
switches do not share attack lists.
To add an entry to the list, use the following command:
set rfdetect attack-list mac-addr
The following command adds MAC address aa:bb:cc:44:55:66 to the attack list:
23x0# set rfdetect attack-list 11:22:33:44:55:66
success:
To display the attack list, use the following command:
show rfdetect attack-list
The following example shows the attack list on WSS switch:
23x0# show rfdetect attack-list
Total number of entries: 1
Attacklist MAC
----------------- ----------------- ------ ------------
11:22:33:44:55:66
To remove a MAC address from the attack list, use the following command:
clear rfdetect attack-list mac-addr
The following command clears MAC address 11:22:33:44:55:66 from the attack list:
23x0# clear rfdetect attack-list 11:22:33:44:55:66
success: 11:22:33:44:55:66 is no longer in attacklist.
MAC 11:22:33:44:55:66 is now in attacklist.
Port/Radio/Chan
dap 2/1/11
Nortel WLAN Security Switch 2300 Series Configuration Guide
Rogue Detection and Countermeasures 547
RSSI SSID
-53 rogue-ssid