Nortel 2300 Series Configuration Manual page 254

254 Configuring AP access points
AP Parameters:
set dap auto mode {enable | disable}
set dap auto bias {high | low}
set dap auto upgrade-firmware {enable | disable}
set dap auto group name
set dap auto blink {enable | disable}
Radio Parameters:
set dap auto radiotype {11a | 11b| 11g}
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
set dap auto radio {1 | 2} auto-tune max-power power-level
set dap auto radio {1 | 2} auto-tune max-retransmissions retransmissions
set dap auto radio {1 | 2} auto-tune min-client-rate rate
Enabling the Template
To enable the template for automatic Distributed AP configuration, type the following command:
23x0# set dap auto mode enable
success: change accepted.
Specifying the Radio Profile Used by the Template
The template uses radio profile default by default. To use another radio profile instead, use the following command:
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
The following command changes the template to use radio profile autodap1 for radio 1:
23x0# set dap auto radio 1 radio-profile autodap1
success: change accepted.
Note.
You must configure the radio profile before you can apply it to the template.
Displaying Status Information for APs Configured by the Template
To display status information for APs configured by the template, type the following command:
23x0# show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan 'default'), AP model: AP-2330,
====================================================
State:
320657-A
manufacturer: Nortel, name: DAP100
operational