Enabling The Spanning Tree Protocol - Nortel 2300 Series Configuration Manual

Wlan security switch

Hide thumbs Also See for 2300 Series:

Table of Contents

312 Configuring and Managing Spanning Tree Protocol

Enabling the Spanning Tree Protocol

STP is disabled by default. You can enable STP globally or on individual VLANs.

To enable STP, use the following command:

set spantree {enable | disable}

[{all | vlan vlan-id | port port-list vlan-id}]

To enable STP on all VLANs configured on an WSS switch, type the following command:

23x0# set spantree enable

success: change accepted.

To verify the STP state and display the STP parameter settings, enter the show spantree command. For infor-

"Displaying Spanning Tree Information" on page