Figure 92 Enter Monitor / Control Connection Information Dialog Box - Nortel BayStack Instant Internet 100-S Using Manual

180 Chapter 6 IP security and VPN
10 In the Remote Addresses area, click Add to enter the IP addresses of the
remote site that is accessed through the tunnel. For more information, refer to
"Adding a local or remote IP address" on page
11 Click OK to close the IP Configuration dialog box. Determine whether or not
you want to monitor or control the connection.
•
•

Figure 92 Enter Monitor / Control Connection Information dialog box

12 Choose whether you want to monitor or control the connection by clicking the
option.
For more information, refer to
13 Enter the IP address of a device that is reachable through the tunnel and
representative of the desired connectivity (usually the private address of the
remote unit).
14 Select the source interface of the connection being monitored or controlled.
15 Click OK.
300868-G
No – The connection is not monitored or controlled. Skip to step 16.
Yes – You are given the opportunity to configure the monitor and control
settings.
The Enter Monitor / Control Connection Information dialog box opens
(Figure 92).
172.
"Using Pings" on page 173.