Ignore Chars; Ignore Mode - Printronix SL5000 User Manual

Ignore Ch#1
Specifies character 1 for the character filtering option. Valid decimal values
are from 0 through 255.
The factory default is 0.
Ignore Ch#2
Specifies character 2 for the character filtering option. Valid decimal values
are from 0 through 255.
The factory default is 0.

Ignore Chars

•
Disable. Character filtering is not enabled.
•
Char 1. Character 1 will be filtered. Select the option "Ignore ch#1" to
specify character 1.
•
Char 2. Character 2 will be filtered. Select the option "Ignore ch#2" to
specify character 2.
•
Char 1&2. Characters 1 & 2 will be filtered. Select the options "Ignore
ch#1" and "Ignore ch#2" to specify values for these characters.
The factory default is Disable.
Ignore Dots
•
Disable. The VGL expects position values to be specified in tenth inches
and dot rows.
•
Enable. Causes the VGL to expect position values to be specified in only
1/10ths of an inch. If the dot position is also given, it is treated as text.
The factory default is Disable.
Ignore ^Lxx Cmd.
•
Disable. The factory default.
•
Enable. The Form Length commands ^Lxx and ^Hxx will be ignored, and
the form length will be determined by the "Form Length" menu in the
LP+ menu.
The factory default is Disable.

Ignore Mode

This parameter instructs the IGP to ignore the character selected under the
Select Character menu.
•
Disable. The IGP does not ignore any characters.
•
Enable. The IGP ignores the character specified in the Select Character
menu.
The factory default is Disable.
Emulation Submenus
217