MEDIA
CONTROL
(from page 118)
Peel-Off
Continuous
1
Mode
Mode
Fast*
Standard*
Standard
Tear-Off
Tear-Strip Full
Cut Strip
TOF Adjust
Ribbon
Calibrate
3
0.00 to 0.40 inches
Standard*
Forward Only
Notes:
* = Factory Default
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL
menu).
1
The Peel-Off option under Media Handling must be enabled for this menu to function.
2
The Continuous option under Media Handling must be enabled for this menu to function.
3
In increments of 0.01 inch.
4
Default is "Fine" on Small Label Printer.
5
Menu available only if Small Label Printer option is installed.
MEDIA CONTROL Submenus
Print Intensity
This option specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is from -15 to +15.
The factory default is -3.
TOF Detect
2
Fault
3 Labels*
Disable*
9 Labels
Enable
1 Label
Reverse
1
Speed
2 ips*
1 to 6 ips
MEDIA CONTROL Submenus
Ticket Save
TOF Adjust
Mode
Mode
Disable*
Enable
Label,
4, 5
Resolution
Coarse*
Fine
119