Printronix SL5000 User Manual page 275

Time To Go
This displays the Time to Go status on the LCD in hundredths of an hour.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu. When the power cart charger is connected to an
AC outlet, the Time To Go will be 0.00 Hours. This message updates
approximately every two minutes.
Percent Charge
This displays the Charge Percentage in tenths of a percent.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu.
Current Draw
This displays the Current Draw in hundredths of an amp.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu.
Voltage
This displays the Voltage in hundredths of a volt.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu.
Amp-Hour Used
This displays the Amp-Hour Used in tenths of an amp hour.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu.
Time To Go Alert
This allows you to set the minimum Time to Go value for determining when a
"RECHARGE BATTERY" warning occurs. When the printer receives a status
from the battery that is less than the value of the Time To Go menu, the
"RECHARGE BATTERY" warning displays on the LCD.
The range is .3 - 12.0, and the factory default is 1.0 Hours.
NOTE: This menu is available only when you select "Enable" in the Battery
Monitor submenu.
BATTERY CONTROL Submenus
275