Main Menu - Printronix SL5000 User Manual

Main Menu

QUICK
SETUP
(page 106)
Print Intensity
Print Speed
4
Print Mode
Media Handling
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
1
Gap/Mark Sensor
Auto Calibrate
3
Validator Funct.
Active IGP Emul
7
xxx Diagnostics
Save Config.
Power-Up Config.
5
SMT: Status
6
PAA: Select Tool
RFID
2
CONTROL
Refer to the RFID
Refer to the Online
Labeling Reference
Data Validator
Manual .
User's Manual
Press . . to select the next main menu.
.
Press ↓ or ↑ to move within each main menu.
−
Press + or to cycle through each possible option or value.
NOTES:
Italicized items are available only when you enable Admin User
(under PRINTER CONTROL).
1
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as
shown in Table 6 on page 138. If you change the Gap/Mark Sensor
or Paper Out Sensor, you must recalibrate the media.
2
This menu appears only if an RFID encoder is installed.
3
This menu appears only if a Validator is installed.
4
This menu will not appear on Direct Thermal only printers.
5
This menu appears only if RFID is installed and there is no CST
bundle in the Flash File System.
6
This menu appears only if RFID is not installed and there is a CST
bundle in the Flash File System.
7
xxx represents the emulation name selected in the Active IGP Emul
menu.
3
VALIDATOR
Load Config.
Save Config.
Print Config.
Delete Config.
Power-Up Config.
Protect Configs.
Name Config 1
Name Config 2
Name Config 3
Name Config 4
Name Config 5
Name Config 6
Name Config 7
Name Config 8
Reset Cfg Names
Auto Save
CONFIG.
CONTROL
(page 115)
95