Printronix SL5000 User Manual page 317

Displayed Message
06 HOST REQUEST
08 HOLD PRINT
TIMEOUT
15 COMM CHECK
22 INVALID ADDR
27 CU TIMED OUT
28 CU NOT ENAB
Table 17. LCD Message Troubleshooting
Can User
Explanation
Correct?
Yes Status message: in CT
emulation, the host
computer or printer
controller requires
attention.
Yes Status message: in CT
emulation, the printer
was offline more than
10 minutes and the
"Intervention Required"
parameter is set to
"Send to Host."
Yes/No Communication Check:
a message that
appears in the CT
emulation meaning the
line is not active on a
twinax interface.
Yes Invalid Address: poll
time-out on the twinax
interface indicating the
unit address is not
recognized by printer.
Yes Controller Unit Timed
Out: the printer was not
enabled for one minute
or more on a coax
interface.
Yes Controller Unit Not
Enabled. Poll time-out-
error. The printer was
not polled for one
minute across a coax
interface.
Fault Messages
Solution
Not a printer problem.
Press PAUSE to put the printer
online.
1. Check your network for
proper operation.
2. Try a different cable from a
known good device.
3. If the problem persists,
contact your authorized
customer service
representative.
Have the system administrator
make sure the printer address
is correct.
Check the cable connection
and host system. (Refer to the
line problem determination
procedures, as recommended
by the host system.)
Check the cable connection
and host system. (Refer to the
line problem determination
procedures, as recommended
by the host system.)
317