3270 Params; Lead-In Chars - Printronix P7010 User Manual

Translation Tbl
Prints out a table of the Coax interface's current character set. This operation
is valid only when the TN3270 interface is the current interface.
Active Char Set
Specifies which character language set will be the active set.
•
Secondary Sets (default)
•
Primary Sets
Prt Partial Line
•
Enable (default). When this option is enabled, it forces the printer to print
if a partial line is in the printer (i.e. line not ending with a LF).
•
Disable. When disabled, the last partial line of data will not be printed.
Early Print Cmpl
Early Print Complete allows the printer to send Print Complete status to the
host before the printer is actually done printing all data. Early Print Complete
is only available if the IPDS feature is installed.
•
Disable (default). Means the printer will suppress the Early Print
Complete response until all printing is complete.
•
Enable. Means the printer will send an acknowledgement to the host
when it is able to accept more data.
NOTE: When an Early Print Complete is enabled and an error occurs, the
data in the printer will remain in the buffer (regardless of the setting of
the Cancel Buffer option). It is recommended that local procedures be
followed to recover from the error.
Do not select Early Print Complete while a print job is in progress. If
this is done you will need to restart the printer.
PTX Transparent

Lead-in Chars

You can enable additional printer features which are not accessible through
standard TN3270 emulations. To access these features, send text commands
in the data stream. The commands must have a start and end code. Four sets
are available:
•
Set 1. start code: <% (default)
stop code: >
¬¬
•
Set 2. start code:
stop code: $
•
Set 3. start code: _%
stop code: _
•
User Defined.

3270 Params

123