Printronix SL5000 User Manual page 326

Chapter 6
Restore The Printer To Operation
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
E06 NOT ALIGNED
See User Manual
E07 ILLEGAL INS
See User Manual
E08 FLOATINGPNT
See User Manual
E-NET INIT
E-NET READY
E-NET RESET
EC SOFTWARE FAIL
See Manual
326
Can User
Explanation
Correct?
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes Ethernet is initializing.
Yes Ethernet has finished
initializing.
Yes Ethernet interface is
being reset.
Yes/No Engine control
software failure.
Solution
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
No action required.
No action required.
No action required.
Power off the printer for 15
seconds, then power back on.
If the problem persists, contact
your authorized customer
service representative.