Chapter
3
BATTERY CONTROL
BATTERY CONTROL
BATTERY
CONTROL
(from page 105)
Battery
Time
1
Monitor
To Go
Disable*
xxx.xx Hours
Enable
Time To
High Volt
1
Go Alert
Alert
1.0 Hours*
16.0 Volts*
.3 - 12.0 Hours
12.5 - 16.0 Volts
BATTERY CONTROL Submenus
Battery Monitor
•
Disable (the default). When set to Disable, the other Battery Control
menus do not display. The Serial Port is restored to normal use, and the
Serial Port menu displays.
•
Enable. When set to Enable, the other Battery Control menus display.
The Serial Port is reserved for monitoring the power cart, and the Serial
Port menu does not display.
When Battery Monitoring has been enabled and the printer is online, the
second line of the LCD message displays the time remaining as "Batt
xxx.xx Hrs."
The factory default is Disable.
274
Percentage
Current
1
Charge
Draw
2
2
xxx.x %
+/- xx.xx Amps
Low Volt
1
1
Alert
9.5 Volts*
8.5 - 11.5 Volts
Notes:
* = Factory Default
1
Available only when Battery Monitor is set to Enable (in the BATTERY
CONTROL menu). Functional only when the printer is connected to a
power cart, via serial interface, and the cart has an ICP (Intelligent
Control Panel) option.
2
You cannot change this value; it is a display only item.
1
Voltage
Amp-Hour
1
2
2
xx.xx Volts
+/- xx.x Amp-Hours
Low Volt
1
Fault
1
Used
2