Configuring The Switch; Configuring Quick Start Using Acli - Avaya 5900 Series Quick Start Configuration

Connecting and configuring the switch

Configuring the switch

Use the procedures in this section to configure the switch using Quick Start.

Configuring Quick Start using ACLI

The Install script consists of a series of prompts that are used to set up the minimum
configuration information.
You must enter the following information when prompted:
• Quick start VLAN
• IP address
• Subnet mask
• Default gateway
• Management subnet mask
• Management IP address
• Management default gateway
• Read-only community string
• Read-write community string
• Management IPV6 address
• Management IPV6 default gateway
Before you begin
• Connect to the switch using the terminal or terminal emulation application.
Procedure
1. Press
CTRL + Y to obtain a CLI prompt.
2. Enter enable
3. Enter install
The switch setup utility banner appears.
4. Enter the VLAN ID for the Quick Start at the following prompt:
Please provide the Quick Start VLAN <1–4094> [1]:
5. Enter the IP address at the following prompt:
Please provide the in-band IP Address[192.168.1.1]:
6. Enter the sub-net mask at the following prompt:
October 2015 Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
22