Konica Minolta bizhub pro 1050 User Manual page 77

Be sure that the side guide plates and rear edge guide are securely aligned to
the paper; otherwise the machine cannot detect the correct paper size, or
machine trouble may occur.
5.
When paper is seated properly, close the paper feed roller.
6.
Push in the tray until it locks into place.
Needless Tab Paper Exit
This function sets the machine to discharge the oddments of a set of tabbed
sheets automatically if the tabbed original count is less than the number of
tabbed sheets in a set, so that the next copy job can be started afresh with the
1st tabbed sheet.
Three tabbed
Originals
the five sheets.
For details of Tab Paper mode, see p. 9-16.
Use the User Setting mode to specify whether or not to use the Needless Tab
Paper Exit function. See p. 4-15 of POD Administrator's reference.
If the machine with this function enabled stops the current job due to a trouble
such as paper misfeed, a message will appear on the touch panel to prompt
you to check that the tabbed sheet tray source is prepared for the next copy
job to start with the 1st tabbed sheet.
Needless Tab Paper Exit may not be allowed depending on the finisher type
mounted on the machine.
1
2
3
Copy from the 1st to 3rd tabbed sheet,
Load all
Loading Paper (continued)
1
2
3
and automatically descharge
4th and 5th tabbed sheets.
4-7