Konica Minolta bizhub pro 1050 User Manual page 354

The tandem mode cannot be selected/continued in the cases shown below.
The message "Please wait/ Reserve is not available in Tandem machine,"
"Tandem machine error/ Please check tandem machine," or "Please check
tandem machine" will be displayed, as required.
• The tandem mode cannot be selected while the tandem machine is in the
off state, due to Auto shut-off. Press [Power Save] to release it.
• Selected tandem mode will be released automatically when the tandem
machine activates Auto shut-off. Press [Power Save] to release it, then
select the tandem mode again to restart the procedure.
• When any problem occurs in the tandem machine, such as a paper
misfeed or lack of paper, the tandem machine will be unavailable for
printing; however, the problem will not cause tandem mode to be released.
Take the appropriate troubleshooting measures to be ready for copying.
• Tandem printing job cannot be started if 100 reserve jobs (not in tandem
mode) are entered on the tandem machine. Wait until the reserve jobs are
completed on the tandem machine.
4.
Select the desired copying conditions on the master machine.
Ordinary copying operation is still available on the tandem machine during the
tandem mode setting.
Corresponding tray sizes on the master and tandem machines should be the
same when using multiple trays for a single job.
5.
Enter print quantity on the master machine, using the keypad.
When a print quantity amount of 100 is entered, the master and tandem
machines will each copy and output 50 sets.
• Print quantity must be set for [2] or more copies to activate the tandem
mode.
• When the print quantity entered is an odd number, the master machine will
copy and output one sheet/set more than the tandem machine to
accommodate the job.
6.
Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass of the master machine.
12-58
Using Two Copiers in Tandem (continued)