Zoom; To Copy In 1.000 Magnification Mode; To Change Magnification Ratio - Konica Minolta bizhub pro 1050 User Manual

Zoom

In the initial settings on the Copy Screen, the magnification is automatically set at
"1.000" (full size).
This section describes how to change the magnification ratio.

To Copy in 1.000 Magnification Mode

Follow this procedure to make a 100% copy of the original image.
1.
Close the ADF securely, then press [Reset].
The initial settings are restored. Check that ×1.0 is highlighted to indicate
that the 1.000 magnification is selected.
The initial settings may be altered by the machine manager. Details can be
referred in POD Administrator's reference. (Utility Menu Screen>03 Copy
Setting>01 Reset Setting>01 Initial Setting)
2.
Select additional copy conditions, as desired.
Specifying paper size will release 1.000 magnification and set Auto Zoom
automatically. In this case, touch x1.0 to highlight it again.

To Change Magnification Ratio

The following four modes are provided.
• Manual Zoom (proportional): 0.250 to 4.000 in 0.001 (0.1%) increments
• Manual Zoom (individual): Vertical and horizontal dimensions can be specified
individually from 0.250 to 4.000 in 0.001 (0.1%) increments.
• Enlarge/Reduce: Select from the eight ratios (0.500, 0.647, 0.772, 0.785, 1.214,
1.294, 1.545, 2.000) provided on the screen.
• Preset Zoom: Select from the three ratios previously programmed.
The preset zoom ratio setting is described in POD Administrator's reference
(03 Function Setting>04 Preset Zoom Setting).
1.
Touch Zoom on the Copy Screen.
9-24