Installation; Before You Begin; Connecting The If-200; First Time Setup - Muratec Office Bridge IF-200 Operating Instructions Manual

2. Installation

2.1. Before You Begin

Remove the IF-200 from the box carefully and remove all packing material. Verify that
you have the following items:
IF-200 product
AC adapter
Telephone line cord
Category 5 patch cable
Installation Guide and Operation Guide

2.2. Connecting the IF-200

All connections are made on the rear panel of the IF-200. Figure 1 illustrates the real
panel of the IF-200.
TEL
LINE
Make sure the IF-200 power switch is in the OFF position before making any
connections. To avoid any danger of shock from the telephone line, connect the
telephone line cord to the IF-200 before connecting it to the wall jack. Do not

2.2.1. First Time Setup

1. If you are using an existing fax machine, unplug the telephone line cord from the
back of the fax machine (the one that goes to the telephone wall jack). Do not touch
the metal contacts on the end of the cord. Now, plug that line cord into the "TEL
LINE" jack on the back of the IF-200.
If you are installing your fax machine for the first time, plug the telephone
NOTE:
line cord that came with your fax machine into the "TEL LINE" jack on the
back of the IF-200. Plug the other end of the telephone cord into the RJ-11
telephone wall jack.
SERIAL
FAX
Figure 1. Rear Panel
CAUTION
install this equipment during lightning storms.
12VAC
POWER
LAN
1AMP
LINK ACTV
7