Additional Printer Setup; Installing Internal Options - Lexmark XM9100 Series User Manual

Additional printer setup

Additional printer setup

Installing internal options

CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Available internal options
•
Memory card
–
DDR2 DIMM
–
Flash memory
•
Fonts
• Firmware cards
– Forms and Bar Code
–
PRESCRIBE
–
IPDS
TM
•
Lexmark Internal Solutions Ports (ISP)
–
Standard 10/100/1000 Ethernet
TM
– MarkNet N8350 802.11 b/g/n wireless print server
–
MarkNet N8352 802.11 b/g/n wireless print server
Accessing the controller board
Note: Use the screwdriver located inside the bottom front door of the printer.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
27