53 Unformatted Flash Detected; 54 Network [X] Software Error; 54 Serial Option [X] Error; 54 Standard Network Software Error - Lexmark X952DTE User Manual

Troubleshooting

53 Unformatted flash detected

Try one or more of the following:
•
Touch Continue to stop the defragment operation and continue printing.
• Format the flash memory. If the error message remains, the flash memory may be defective and require replacing.

54 Network [x] software error

Try one or more of the following:
•
Touch Continue to continue printing.
• Turn the printer off, wait for about 10 seconds, and then turn the printer back on.
• Upgrade (flash) the network firmware in the printer.

54 Serial option [x] error

Try one or more of the following:
•
Check that the serial cable is properly connected and is the correct one for the serial port.
• Check that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer
and host computer.
•
Touch Continue to continue printing.
•
Turn the printer power off and then back on to reset the printer.

54 Standard network software error

Try one or more of the following:
• Touch Continue to continue printing.
•
Turn the printer off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.

55 Unsupported option in slot [x]

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the unsupported option card from the printer system board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
307