Product Faq; What Is Shdsl, Shdsl.bis; How Can I Manage P-793H V2; What Is The Default Password For Web Configurator - ZyXEL Communications P-793H v2 Support Notes

Product FAQ

1. What is SHDSL, SHDSL.bis?

SHDSL stands for Symmetric High-data-rate Digital Subscriber Line. SHDSL
bases on TC-PAM (Trellis Coded Pulse Amplitude Modulation) which offers
symmetrical transmission speed up to 2.30 Mbps (2-wire mode).
SHDSL.bis boots SHDSL performance to approximately 5.70 Mbps (2-wire
mode) or 11.4 Mbps (4-wire mode).

2. How can I manage P-793H v2?

Multilingual Embedded Web GUI for Local and Remote management

SMT via console.

Telnet support (Administrator Password Protected ) for remote

configuration change and status monitoring
 FTP/ TFTP sever, firmware upgrade and configuration backup and
restore are supported (Administrator Password Protected)

3. What is the default password for Web Configurator

There are two different accounts for P-793H v2 Web Configurator: Common
User Account and Administrator Account.
By factory default the password for the two accounts are:
Common User Account: user
Administrator Account: 1234.
You can change the password after you logging in the Web Configurator.
Note: By default, the password is "user".
4. What‟s the difference between „Common User Account‟ and
„Administrator Account‟?
For Common User Account, it can only access the status monitor of P-793H v2
and check the current system status.
For Administrator Account, besides accessing the status monitor of P-793H v2,
it can also access Wizard setup / Advanced setup of P-793H v2.
Moreover, only with Administrator Password, you could manage the P-793H v2
via FTP/TFTP or Telnet.

5. How do I know the P-793H v2's WAN IP address assigned by the ISP?

You can view "IP Address: x.x.x.x" shown in Web Configurator „Status-
>Device Information ->WAN Information‟.
All contents copy right © 2010 Zy XEL Communications Corporation.
P-793H v 2 Support Notes
?
11