Canon iR105 Service Manual page 285

CHAPTER 4 INSTALLATION
No.
7 Fit the positioning binding screw [1]
(M4x14) so that the upper arm [2] is at the
angle desired by the user; then, fully
tighten the binding screw that was
temporarily tightened.
Lead the control panel harness [3] through
the 2 wire saddles [4]. At this time, check
to make sure that the wire saddle [5] at the
rear matches the marking [6] on the
control panel harness.
8 Pinch the control panel harness with a
harness clip [1], and fit it to the upper
arm.
Hook the claw [2] found on the left side
of the fate upper arm cover [3], and put it
over the upper arm.
Keep the harness clip [1] so
that the side with a
protrusion (thicker side) is at
the bottom.
The harness clip [1] will
separate into two during the
work. Continue the work, as
it will not affect its function.
4-26
Work
COPYRIGHT© 2001 CANON INC.
Checks/remarks
[1]
[2]
[4]
[5]
F04-208-07
[2]
F04-208-08
2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
[1]
[2]
[6]
[3]
[1]
[3]