Canon iR105 Service Manual page 706

• Finisher (from E500 to E514)
E500
Main cause The finisher controller PCB is faulty (data communication with the copier).
The DC controller PCB is faulty.
Condition
0000 The communication between copier and finisher is disrupted and,
E501
Main cause The finisher controller PCB is faulty (data communication with the slave
CPU).
Condition
0000 The communication between the master CPU (IC106) and the slave
E503
Main cause The saddle stitcher controller PCB is faulty. The finisher controller PCB is
faulty (data communication with the saddle).
Condition
0000 The communication between saddle stitcher controller PCB and
E505
Main cause The EEPROM is faulty. The finisher controller PCB is faulty. The punch
driver PCB is faulty.
Condition
0001 The checksum of the EEPROM is faulty (offset value error of the
0002 The checksum of the EEPROM is faulty (D/A conversion value er-
COPYRIGHT© 2001 CANON INC.
in addition, is not recovered despite retransmission for 5 sec. The
disruption and the recovery have been repeated three times in 5
sec. (This error is detected by the finisher.)
CPU (IC125) is disrupted.
the finisher controller PCB is disrupted.
aligning plate).
ror of the motor drive or sensor adjustment value).
2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
ERROR CODE
E-15