Canon iR105 Service Manual page 696

Hide thumbs Also See for iR105:
Table of Contents

Advertisement

E015
Main cause
The pickup motor (M2) is faulty. The DC controller PCB is faulty.
Condition
0000 The motor lock signal is not detected for 2 sec or more after the
E019
Main cause
The waste toner case is full. The waste toner case full sensor (PS19) is
faulty. The DC controller PCB is faulty.
Condition
0000 More than a specific number of pages are printed without dispos-
E020
Main cause
The hopper connector is disconnected. The toner feed motor (M18) inside
the hopper is faulty. The magnet roller drive clutch (CL1) inside the hopper
is faulty. The toner sensor (TS3) inside the developing assembly is faulty.
The DC controller PCB is faulty.
Condition
0000 Although the developing assembly is supplied with toner, the ab-
0010 The power is turned off and then on without clearing the error.
E025
Main cause
The toner feed motor (M6) inside the cartridge is faulty. The DC controller
PCB is faulty.
Condition
0000 The DC controller PCB detects an overcurrent flowing to the toner
COPYRIGHT© 2001 CANON INC.
pickup motor drive signal has been generated.
ing of the waste toner after the waste toner case has been found to
be full.
sence of toner inside it is detected for 3 sec or more.
feed motor (M6) inside the cartridge for 10 sec or more twice. (In
response to the first detection, it indicates the message "Shake the
Toner Case, and Set.")
2000 2000 2000 2000
CANON iR105 REV.0 JULY 2001
ERROR CODE
E-5

Advertisement

Table of Contents
loading

Table of Contents