Canon iR105 Service Manual page 126

Hide thumbs Also See for iR105:

Table of Contents

CHAPTER 2 NEW FUNCTIONS

d. Stringing the Grid of the Primary Charging Assembly

1) Check to make sure that the 4 screws

used to keep the front/rear block and

shielding plate are not loose.

Then, hook the end of the charging wire

on stud A, and then route it for 41 runs;

then, hook it on B, C, and D; thereafter,

fit it between the double washers [1],

give a 1/2 turn around the screw [2],

and secure it in place.

2) Loosen the screws [1], [2], [3], [4];

then, tighten the screw [5] to a torque of

1.5 ±0.2 kg•cm. thereafter, tighten the

screws [1], [2], [3], [4] to a torque of 8

kg•cm in the order indicated.

2000 2000 2000 2000

CANON iR105 REV.0 JULY 2001

Chapters

Table of Contents