Xfp Uplink Module; Chassis Status Leds In Ex4200 Switches; Figure 8: Xfp Uplink Module - Juniper EX4200 Hardware Manual

Hide thumbs Also See for EX4200:
Table of Contents

Advertisement

XFP Uplink Module

Related
Documentation

Chassis Status LEDs in EX4200 Switches

Copyright © 2015, Juniper Networks, Inc.
Figure 8 on page 21
shows the XFP uplink module, which provides two ports for 10-gigabit
XFP transceivers.

Figure 8: XFP Uplink Module

Port 0
XFP uplink modules are shipped with a dust cover preinstalled in one port.
The XFP uplink module requires Junos OS for EX Series switches, Release 9.0 or later.
Network Port LEDs in EX4200 Switches on page 24
Uplink Modules Connector Pinout Information for EX4200 Switches on page 130
Pluggable Transceivers Supported on EX4200 Switches on page 81
SFP+ Direct Attach Cables for EX Series Switches on page 118
Example: Configuring Aggregated Ethernet High-Speed Uplinks Between an EX4200
Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between an
EX4200 Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
Installing an Uplink Module in an EX4200 Switch on page 215
Troubleshooting Virtual Chassis Port Connectivity on an EX4200 Switch on page 262
The front panel of an EX4200 switch has three LEDs on the far right side of the panel,
next to the LCD panel (see
Chapter 2: Chassis Components and Descriptions
Status LED
Status LED
Port 1
Link/Activity
Link/Activity
LED
LED
Figure 9 on page
22).
21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX4200 and is the answer not in the manual?

Table of Contents