Switching The Operation Mode - Yaesu FTM-100DR Operating Manual

Receiving
2
Rotate the DIAL to select [8 CONFIG], then press
.
The menu list appears.
3
Rotate the DIAL to select [7 FM AM STEP], then
press .
4
Rotate the DIAL to select the desired frequency step.
The frequency steps change in the following order:
"AUTO" → "5.00 KHz" → "6.25 KHz" → "8.33 KHz"
→ "10.00 KHz" → "12.50 KHz" → "15.00 KHz" →
"20.00 KHz" → "25.00 KHz" → "50.00 KHz" →
"100.00 KHz"
Tips • The default setting: AUTO
• T he 8.33 kHz frequency step can be selected only on
the Air band.
• T he 5 kHz, 6.25 kHz or 15 kHz frequency step cannot
be selected on 480 MHz or higher frequency.
5
Press and hold
The selected frequency step is set, and the display returns to the previous operating
display.
Tip
To return to the previous operating display press

Switching the operation mode

The operating mode can be switched between VFO mode and MEMORY mode. In VFO
mode, the operating frequency may be freely adjusted; in MEMORY mode, the memory
channels are recalled and displayed on the screen for operation.
1
Select the desired operating band.
2
Press .
The display switches to MEMORY mode.
or and the memory channel number appear
on the operating band name display.
Tips
• appears on the A-band.
• appears on the B-band.
When a name (tag) has been assigned to the
memory channel, the tag appears on the frequency
display or the sub-band display.
38
for over one second.
3 times.