Using The Tone Squelch Function - Yaesu FTM-100DR Operating Manual

Communicating with specific stations

Using the tone squelch function

1
Press and hold
The Setup menu appears.
2
Rotate the DIAL to select [4 SIGNALING], then press
.
The menu list appears.
3
Rotate the DIAL to select [4 SQL TYPE], then press
.
4
Rotate the DIAL to select [TONE SQL], then press
for over one second.
Tips • Rotating the DIAL changes the squelch type in the
following order:
"OFF", "TONE ENC", "TONE SQL", "REV TONE",
"DCS", "PR FREQ", "PAGER", "DCS ENC"*, "TONE
DCS"*, "DCS TSQL"*
* To display these squelch types, from the Setup menu,
select [4 SIGNALING] → [9 SQL EXPANSION]
followed by "1 ON".
• Instead of following the steps 1 to 4 above, you can
change the squelch type by pressing and holding
Displays
only when receiving tone signals of the set frequency.
Tip
A bell tone (beep) may be set to sound when signals containing a corresponding CTCSS tone are
received. See "Notification of incoming calls from partner stations using the bell function" on page
89.
82
for over one second.
for over one second.
on the screen. The squelch opens