Using The Clone Function - Yaesu FTM-100DR Operating Manual

Copying the radio data to another transceiver
8
Rotate the DIAL to select [OK?], and then press
.
The data selected in step 7 is copied from the
microSD memory card. While copying, "Reading..."
appears, and when completing, it disappears.

Using the clone function

Using the clone function, all data saved in the transceiver can be copied directly to other
FTM-100 transceivers.
Example: When using the clone function in two FTM-100DR transceivers
1
Turn off the both transceivers.
2
Connect the optional clone cable "CT-166" to the
DATA jack on the rear side of the transceivers.
3
Turn on both transceivers.
4
Press and hold
The Setup menu appears.
5
Rotate the DIAL to select [13 RST/CLONE], then
press .
The menu list appears.
6
Rotate the DIAL to select [7 CLONE], then press
.
Displays the screen where the copy direction may be
selected.
7
On the transceiver from which data is to be copied,
rotate the DIAL to select [1 This radio → other],
then press
The confirmation screen appears.
8
On the transceiver to which data is to be copied,
rotate the DIAL to select [2 Other → This radio],
then press
The confirmation screen appears.
9
On the transceiver to which data is to be copied,
rotate the DIAL to select [OK?], then press
106
for over one second.
.
.
.