Monitoring The Home Channel; Using The Dual Receive Function - Yaesu FTM-100DR Operating Manual

Monitoring the home channel

The FTM-100DR transceiver is equipped with a dual receive function (also known as
dual watch (DW)) which periodically checks for signals on the home channel. When a
signal is detected, the transceiver receives on the home channel.
Example: While receiving signals on 446.500 MHz, dual receive checks the home
channel every 5 seconds.
Receiving frequency
Monitors the home channel at
intervals of about 5 seconds.
Caution
When shipped from the factory, the 144 MHz band home channel is set to 145.000 MHz, while the
430 MHz band home channel is set to 433.000 MHz. The registered home channel frequencies may
be changed as desired. (

Using the dual receive function

1
Rotate the DIAL to tune to a memory channel or VFO receive frequency.
2
Press and hold
The dual receive function is activated and the home
channel is checked approximately every 5 seconds.
When a signal is detected on the home channel,
reception continues until the signal disappears.
The time interval for checking the home channel
may be changed in the Setup menu [5 SCAN] → [4
DUAL WATCH MODE] (page 71).
● Canceling the dual receive function
Press and hold
70
page 54).
for over one second.
again for over one second.
After receiving a signal on the
home channel, the transceiver
continues receiving until the signal
disappears. About 3 seconds after
the signal disappears, the dual
reception starts again.