Intel
®
Server System R1000WT Product Family System Integration and Service Guide
•
Remove the two RMFBUs from their original plastic housing
•
Locate the dual RMFBU plastic housing from the accessory kit
•
Install the RMFBUs one at a time into the Dual RMFBU housing. Each RMFBU is installed at angle with the cable-less
side inserted first. The RMFBU is then rotated into the housing.
•
Position the Dual RMFBU assembly onto the RMFBU mounting plate (see letter 'D') and slide right until the assembly
locks into place (see letter 'E')
•
Using the designated cable routing channels (see Figure 21), route each RMFBU cable to the each add-in SAS RAID
card
Rev 2.2
Figure 74. RMFBU Removal from standard housing
Figure 75. RMFBU installation into Dual RMFBU Housing
Figure 76. Dual RMFBU Assembly Installation
49