Table of Contents
Advertisement
Intel
®
Server System R1000WT Product Family System Integration and Service Guide
2.5 Memory Installation and Removal
2.5.1
Memory Slot population requirements
NOTE: Some system configurations may come with pre-installed DIMM blanks. DIMM blanks should only be
removed when installing a DIMM in the same DIMM slot. Memory population rules apply when installing DIMMs.
•
DIMM Population Rules on CPU-1 – Install DIMMs in order; Channels A, B, C, and D. Start with1st DIMM (Blue
Slot) on each channel, then slot 2, then slot 3. Only remove factory installed DIMM blanks when populating the
slot with memory.
•
DIMM Population on CPU-2 – Install DIMMs in order; Channels E, F, G, and H. Start with1st DIMM (Blue Slot) on
each channel, then slot 2, then slot 3. Only remove factory installed DIMM blanks when populating the slot with
memory.
•
In all R1304WT.... and 1208WT.... based systems – the 3
populated with a DIMM or supplied DIMM blank
2.5.2
DDR4 DIMM Installation
•
Locate the DIMM sockets. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position (see letter "A").
•
Holding the DIMM by the edges, remove it from its anti-static package. Position the DIMM above the socket. Align
the notch on the bottom edge of the DIMM with the key in the DIMM socket (see letter "B").
•
Insert the bottom edge of the DIMM into the socket (see letter "C"). When the DIMM is inserted, push down on the
top edge of the DIMM until the retaining clips snap into place (see letter "D"). Make sure the clips are firmly in place
(see letter "E").
24
rd
Figure 33. DIMM Blank
Figure 34. DDR4 DIMM Installation
DIMM slot on all memory channels must be
Rev 2.2
Advertisement
Table of Contents
