Intel
®
Server System R1000WT Product Family System Integration and Service Guide
•
Locate the SAS/SATA Data cable.
•
NOTE: If installing 2 cables (R1208WTxxxx), select the longer of the two. The 2
this time.
•
Attach P1 (Straight Connector) end of the SAS/SATA Data cable to the specified mini-SAS HD connector on the
backplane (as illustrated in Figure 8).
•
Route the SAS/SATA Data cable along the base of the backplane and underneath the backplane power connector
before bending the cable up along the right chassis sidewall to the back of the system.
Figure 8. Backplane Power Cable and SAS/SATA Data Cable Attachments
•
Attach the P2 (Right Angled Connector) end of the SAS/SATA Data cable to the on-board Mini-SAS HD connectors
for embedded SATA support (see following illustration), or to any available SAS/SAS RAID add-in option. For
installation of other add-in storage options, refer to the appropriate option installation sections in this document.
Rev 2.2
Figure 7. SAS/SATA I/O Cable
Or
nd
SAS/SATA cable is NOT installed at
7