Table of Contents
Advertisement
Intel
®
Server System R1000WT Product Family System Integration and Service Guide
3.3 Power Cord Retention Strap Installation
•
Locate the power cord retention strap from the system accessory kit.
•
Insert the locking tab end of the Retention Strap into the receiver hole located beneath the power cord receptical
on the back of the power supply module (see letter "A").
•
While pushing up the locking tab on the bottom of the slider, adjust the slider to the desired position (see letter "B").
•
Install the power cord into the power cord receptical on the back side of the power supply (see letter "C").
•
Pull the slider strap over the power cord and lock it securely into place (see letter "D").
To remove the power cord from the Retention Strap
•
Push down on the slider tab to release the slider strap.
•
Pull the slider strap back over the power cord.
•
Remove power cord.
38
Figure 59. Power Cord Retention Strap Installation
Retention Strap Receiver
Hole
Rev 2.2
Advertisement
Table of Contents
