Table of Contents
Advertisement
Intel
®
Server System R1000WT Product Family System Integration and Service Guide
•
Remove the system cover. See section 2.2.1.
•
Remove the three screws as shown (see letter "A").
•
Carefully pull up on the I/O Module until it disengages from the server board (see letter "B").
•
If no replacement module is to be installed, re-install the I/O expansion module bay filler panel into the system
back panel (Note: the filler panel snaps into the back panel from the outside of the chassis)
3.6 SATA RAID 5 Upgrade Key – Installation / Removal
3.6.1
Installing the SATA RAID 5 Upgrade Key
•
Remove the SATA 5 Upgrade Key from its packaging
•
Locate the white 4-pin key connector behind the onboard NIC 2 port on the back edge of the server board.
•
To install the key, place it over the connector and confirm the orientation of the key matches that of the connector
•
Press the key down onto the connector.
3.6.2
Removing the SATA RAID 5 Upgrade Key
•
Power off the system and disconnect the power cable(s)
•
Remove the system cover (see section 2.2.1)
•
Using the Key pull tab, pull the key up until it disengages from the connector
Rev 2.2
Figure 63. Installing the SATA RAID 5 Upgrade Key
41
Advertisement
Table of Contents
