Intel
®
Server System R1000WT Product Family System Integration and Service Guide
2.6 Storage Device Installation / Removal
The 1U server system has support for several different storage device options. This section provides
instruction for the installation and removal of front drive bay storage devices.
NOTE: To maintain proper system cooling, all externally accessable drive bays must be populated with a drive carrier.
Each drive carrier must have a hard disk drive (HDD), Solid State Device (SSD), or a supplied drive blank installed.
2.6.1
4 x 3.5" Front Drive Bay Storage
2.6.1.1 3.5" Drive Carrier Extraction
Figure 36. Installing Hot-swap storage devices – 3.5" carrier extraction
•
Remove the drive carrier from the chassis by pressing the green button and pulling open the lever (see letter "A").
•
Pull the carrier out of the drive bay (see letter "B").
2.6.1.2 3.5" Hard Disk Drive Installation
•
Remove the four screws securing the plastic drive blank to the carrier
•
Remove the drive blank from the carrier (see letter "C").
26
Figure 37. 3.5" Drive Installation – Remove the drive blank
Rev 2.2