Wheel Motor - Toro Reelmaster 2000-D Service Manual

Wheel Motor

Front Wheel Motor Removal (Fig. 40)
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units, and stop the en-
gine. Remove the key from the ignition switch.
CAUTION
Operate all hydraulic controls to relieve system
pressure and avoid injury from pressurized hy-
draulic oil.
2. Remove wheel and brake assembly from unit (see
Repair section of Chapter 6 – Chassis).
3. Clean wheel motor and hydraulic connections. Label
all tube hose connections for reassembly purposes. Put
caps or plugs on any hydraulic lines or fittings left open
or exposed.
4. Disconnect tube connections from hydraulic fittings
on motor to be removed. On the left–hand wheel motor,
also disconnect hydraulic hose (4) from hydraulic fitting
on motor. Allow hydraulic oil to drain from tubes and
hose into a suitable container.
5. Support wheel motor. Remove four socket head
screws and lock nuts from support frame. Remove
brake bracket (13), grass shield (14), and spacers (15).
Pull wheel motor from the support frame.
6. Remove hydraulic fittings and O–rings from the
wheel motor.
Front Wheel Motor Installation (Fig. 40)
1. Place and support wheel motor into the support
frame. Insert four socket head screws through the sup-
port frame and wheel motor.
2. Slide spacers, grass shield, and brake bracket onto
the cap screws and wheel motor. Tighten lock nuts onto
cap screws.
3. Remove caps or plugs that were put on any hydraulic
lines or fittings during disassembly.
4. Install hydraulic fittings (5 and 6) onto the wheel mo-
tor. On the left–hand wheel motor, also install hydraulic
fitting (7) onto the wheel motor. Tighten hydraulic fit-
tings.
Hydraulic System
4
10
RIGHT
FRONT
1. Wheel motor (LH shown)
2. Tube connection
3. Tube connection
4. Hyd. hose (LH motor)
5. Hydraulic fitting
6. O–ring (LH motor)
7. Hyd. fitting (LH motor)
8. O–ring
5. Install tube connections to hydraulic fittings on wheel
motor. On the left–hand motor, also install hose connec-
tion (4) to hydraulic fitting (7). Tighten connections.
6. Install wheel and brake to machine (see Repair sec-
tion of Chapter 6 – Chassis).
7. Follow Hydraulic System Start–up procedures.
Page 4 – 52
3
8
5
16
2
12
15
13
Figure 40
9. O–ring (LH motor)
10. Socket head screw
11. Lock nut
12. Support frame
13. Brake bracket
14. Grass shield
15. Spacer
16. O–ring
Reelmaster 2000–D
9 (LH)
7 (LH)
6 (LH)
5
16
1
14
11