Installing The Wheels; Installing The Steering Wheel - Toro Reelmaster 3100-D Operator's Manual

Media and Additional Parts
Description
Ignition key
Operator's Manual
Engine operator's manual
Operator training material
Pre-delivery checklist
Certificate of compliance
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Installing the Wheels

Parts needed for this procedure:
2 Front wheel assembly
1 Rear wheel assembly
Procedure
Important:
The rim and tire of the rear wheel is
narrower than that of the front 2 rims and tires.
1. Mount a wheel assembly onto the wheel hub
with the valve stem aligned outward.
2. Secure the wheel to the hub with the lug nuts,
and torque the nuts in a crossing pattern to 61
to 88 N∙m (45 to 65 ft-lb).
3. Repeat steps 1 and
assemblies.
Qty.
2 for the other wheel
2 Start the engine.
1
Read before operating the machine.
1
1 View before operating the machine.
Check to ensure that the machine has been properly set
1
up.
1 Ensure CE compliance.
2
Installing the Steering
Wheel
Parts needed for this procedure:
1 Steering wheel
1 Steering-wheel cap
1 Large washer
1 Jam nut
1 Screw
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure 3).
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft
3).
12
Use
Figure 3
3. Jam nut
4. Cap
g010834
(Figure