Toro Reelmaster 2000-D Service Manual page 83

CAUTION
The extension spring is under tension and may
cause personal injury during installation. Use
caution when installing the spring to the neutral
arm.
D. Install extension spring and hose to the neutral
arm and pump support.
8. Install pulley to the taper lock bushing.
A. Place pulley to the bushing. Align non–threaded
holes of pulley with threaded holes of bushing.
B. Secure pulley to bushing with cap screws and
lock washers. Torque cap screws from 90 to 120 in–
lb (10.2 to 13.6 N–m) in a circular pattern.
C. Verify alignment across engine and pump pulley
faces with a straight edge. The gap between both
faces must not exceed 0.030" (0.8 mm).
Reelmaster 2000–D
9. Install drive belt to the pulleys (see Hydraulic Pump
Drive Belt).
10.Check traction drive for neutral and neutral switch
adjustment (see Traction Unit Operator's Manual).
11. Remove plug from the hydraulic reservoir.
12.Follow Hydraulic System Start–up procedures.
Page 4 – 47 Hydraulic System