Skid Kit Installation - Toro Reelmaster 2000-D Service Manual

Skid Kit Installation

1. Remove front roller from the cutting unit (see Roller
Removal).
2. Align skid slots with the angle bracket holes on the
cutting unit.
3. Secure skid to the cutting unit with both flange head
screws, flat washers, and lock nuts.
4. Repeat steps 1 through 3 on the other side of the cut-
ting unit.
5. Adjust skid height as necessary by loosening lock
nuts and flange head screws. After skid height adjust-
ment, retighten fasteners.
Cutting Units
3
2
1. Skid
2. Angle bracket holes
3. Flange head screw
Page 7 – 20
4
1
Figure 18
4. Flat washer
5. Lock nut
Reelmaster 2000–D
5