Toro Reelmaster 2000-D Service Manual page 29

Removal (Fig. 9)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open and remove the hood (see Traction Unit Oper-
ator's Manual).
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene–glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
3. Drain coolant from radiator.
A. Slowly remove radiator cap from the radiator.
B. Place drain pan below the radiator drain plug lo-
cated on the bottom of the radiator. Remove plug
and allow coolant to drain.
4. Loosen knobs that secure oil cooler to front radiator
bracket. Unhook and position oil cooler assembly away
from radiator.
5. Disconnect radiator hoses (upper and lower) from
the radiator.
6. Support the radiator assembly before loosening
mounting fasteners.
7. Remove two carriage screws and flange nuts secur-
ing the front radiator bracket to the frame. Remove four
cap screws and flange nuts securing the rear radiator
bracket to the frame.
8. Carefully pull radiator assembly from the machine.
Plug radiator and hose openings to prevent contamina-
tion.
9. As required, remove brackets and shrouds from ra-
diator using Figure 9 as a guide.
Reelmaster 2000–D
Installation
1. Install any removed brackets or shrouds to radiator
using Figure 9 as a guide.
2. Remove any plugs used during the removal proce-
dure.
3. Carefully position radiator assembly to the frame.
Secure radiator with two carriage screws and flange
nuts at the front radiator bracket and four cap screws
and flange nuts at the rear radiator bracket.
4. Position and secure oil cooler to front radiator brack-
et.
IMPORTANT: Make
doesn't contact fan belt after assembly.
5. Connect hoses (upper and lower) to the radiator.
6. Make sure radiator drain plug is tight. Fill radiator
with coolant (see Traction Unit Operator's Manual).
7. Install hood on the machine.
Page 3 – 13
sure lower radiator
Engine
hose