Toro Reelmaster 2000-D Service Manual page 31

Hide thumbs Also See for Reelmaster 2000-D:
Table of Contents

Advertisement

12.Close fuel tank shut–off valve.
13.Disconnect hoses from engine.
A. Loosen clamps and disconnect upper and lower
radiator hoses from the engine.
B. At injector pump, loosen hose clamp and discon-
nect fuel hose from the fuel filter/water separator
(Fig. 12). Plug hose to prevent leakage and contami-
nation.
C. At injector pump, loosen hose clamp and discon-
nect the return to tank fuel hose (Fig. 12). Plug hose
to prevent leakage and contamination.
14.Disconnect electrical connections.
NOTE: Label all electrical leads for reassembly pur-
poses.
A. Unplug connector with pink and white wires from
the alternator. Remove connector with red wire from
alternator stud.
B. Unplug connector with blue/white wire from the
high temperature shut down switch located on the
water pump behind the fan.
C. Unplug connector with red/black wire from the
fuel valve solenoid in the injector pump.
D. Unplug connector with gray wire from the oil pres-
sure switch located near the engine oil dipstick.
E. Remove connector with red wire from the glow
plugs located on the rear side of the cylinder head.
F. Unplug connector with white wire from the engine
starter motor located below the exhaust manifold.
Remove fusible link connector and positive battery
cable from the starter motor (Fig. 13).
G. Disconnect negative battery cable and black en-
gine wire harness ground wire from the rear side of
the cylinder block (Fig. 13).
H. Remove cap screws and flat washers from R–
clamps (Fig. 14). Position wiring harness and hoses
away from the engine.
15.Remove hydraulic pump assembly (see Service and
Repairs section of Chapter 4 – Hydraulic System).
Reelmaster 2000–D
6
5
3
1. Injector pump
2. Swivel clamp and screw
3. Cable clamp
2
1
3
1. Fusible link harness
2. Positive battery cable
3. Negative battery cable
1. R–clamp locations on cylinder head
Page 3 – 15
1
4
2
Figure 12
4. Fuel line: from filter
5. Fuel line: return to tank
6. Fuel line: injector return
4
Figure 13
4. Wire harness ground
5. Harness R–clamp
1
Figure 14
Engine
5
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents