Toro Reelmaster 2000-D Service Manual page 23

DANGER
Because diesel fuel is highly flammable, use
caution when storing or handling it. Do not
smoke while filling the fuel tank. Do not fill fuel
tank while engine is running, hot, or when ma-
chine is in an enclosed area. Always fill fuel tank
outside and wipe up any spilled diesel fuel be-
fore starting the engine. Store fuel in a clean,
safety–approved container and keep cap in
place. Use diesel fuel for the engine only; not for
any other purpose.
Check Fuel Lines and Connections
Check fuel lines and connections periodically as recom-
mended in the Traction Unit Operator's Manual. Check
lines for deterioration, damage, leaking, or loose con-
nections. Replace hoses, clamps, and connections as
necessary.
Drain and Clean Fuel Tank
Drain and clean the fuel tank periodically as recom-
mended in the Traction Unit Operator's Manual. Also,
drain and clean the fuel tank if the fuel system becomes
contaminated or if the machine is to be stored for an ex-
tended period.
To clean fuel tank, flush tank out with clean diesel fuel.
Make sure tank is free of contaminates and debris.
Reelmaster 2000–D
Fuel Tank Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Close fuel tank shut off valve. Disconnect fuel hose
from the shut off valve.
3. Use shut off valve to empty fuel tank into a suitable
container.
4. Disconnect return fuel hose from fuel tank fitting.
5. Remove fuel tank using Figure 6 as a guide.
Fuel Tank Installation
1. Install fuel tank to frame using Figure 6 as a guide.
Apply thread–locking compound to fuel tank cap screws
and torque screws from 30 to 60 in–lb (3.4 to 6.8 N–m).
2. Connect fuel hose to the shut off valve. Connect re-
turn hose to tank fitting.
3. Fill fuel tank (see Traction Unit Operator's Manual).
Page 3 – 7 Engine